Tech Tip: BMW no start, bad CAS module

Sept. 8, 2017

Vehicle: 2008 BMW 335xi, AWD (E90), L6-3.0L Turbo (N54), Automatic Transmission

Mileage: 118,669

Problem: When trying to start the engine, the starter momentarily engaged then stopped.

Details: The tech found that, while attempting to crank/start the engine, the starter solenoid was only powered for a split second. He connected a scan tool and retrieved an A0C1 (Output Terminal 50) diagnostic trouble code.

The ALLDATA Tech-Assist consultant suggested he open the Car Access System (CAS) module to inspect for signs of burned spots on the circuit board.

Confirmed Repair: When the tech opened the CAS module, he found several burned circuits. He replaced the CAS module. After the repair, the engine started and ran normally.

Information provided by: ALLDATA

Sponsored Recommendations

Celebrating Your Drivers Can Prove to be Rewarding For Your Business

Learn how to jumpstart your driver retention efforts by celebrating your drivers with a thoughtful, uniform-led benefits program by Red Kap®. Uniforms that offer greater comfort...

Guide To Boosting Technician Efficiency

Learn about the bottom line and team building benefits of increasing the efficiency of your technicians in your repair shop.

The Definitive Guide to Aftertreatment Diagnostics

Struggling to clear aftertreatment fault codes? Learn more about different aftertreatment components, fault codes, regen zones, and the best maintenance practices to follow.

Career Minded

The Peterbilt Technician Institute teaches you the skills needed for a lucrative and fulfilling career, transforming students into certified diesel technicians. Maximize your ...